Starting And Stopping - Husqvarna 455e Rancher Operator's Manual

Starting and stopping

WARNING! Note the following before
!
starting:
The chain brake must be engaged when the
chain saw is started to reduce the chance of
contact with the moving chain during
starting.
Never start a chain saw unless the bar, chain
and all covers are fitted correctly. Otherwise
the clutch can come loose and cause
personal injuries.
Place the machine on firm ground. Make
sure you have a secure footing and that the
chain cannot touch anything.
Keep people and animals well away from the
working area.
Cold engine
Starting: The chain brake should be activated when starting
the chain saw. Activate the chain brake by pushing the front
hand guard forwards.
Ignition; choke (A): Set the choke control in the choke
position. This should automatically set the stop switch to the
start position.
Start throttle: The correct choke/start throttle setting is
obtained by moving the control to the choke position.
Air purge (B): Press the air purge repeatedly until fuel begins
to fill the bulb. The bulb need not be completely filled.
B
Decompression valve (C): Press the valve to reduce the
pressure in the cylinder and make starting easier. You should
always use the decompression valve when starting the
machine. Once the machine has started the valve will
automatically return to its original setting.
C
STARTING AND STOPPING
A
Warm engine
Use the same procedure as for starting a cold engine but
without setting the choke control in the choke position. The
correct choke/start throttle setting is obtained by moving the
choke control to the choke position and then pushing it in
again.
Starting
Grip the front handle with your left hand. Hold the chain saw
on the ground by placing your right foot through the rear
handle. Pull the starter handle with your right hand and pull
out the starter cord slowly until you feel a resistance (as the
starter pawls engage) then pull firmly and rapidly. Never wrap
the starter cord around your hand
As the chain brake is still activated the engine must return to
idling speed as soon as possible by disengaging the throttle
latch in order to avoid unnecessery wear on the clutch
assembly.
Push in the choke control as soon as the engine fire and make
repeated starting attempts. Immediately press and release
the throttle when the engine starts. That will disengage the
throttle latch.
– 21
English