Table of Contents
Advertisement
SC213L Chassis Manual
4-14 Removing the Backplane
The SC213L chassis backplane is located behind the hard drives and in front of
the front system fans. In order to change jumper settings on the backplane, it may
be necessary to remove the backplane from the chassis.
Removing the Backplane from the Chassis
1.
Power down and unplug the system from any power source.
2.
Remove the chassis cover.
3.
Disconnect the cabling to the backplane.
4.
Remove all of the hard drives from the hard drive bays in the front of the
chassis
5.
Remove the two upper screws at the top of the backplane, indicated by the
arrows below.
Figure 4-16: Removing the Screws at the Top of the Backplane
4-18
5
Advertisement
Table of Contents
