Removing The Backplane - Supermicro SC216 Series User Manual

SC216 Chassis Manual

5-11 Removing the Backplane

The SC216 chassis backplane is located behind the hard drives and in front of the
front system fans. In order to change jumper settings on the backplane, it may be
necessary to remove the backplane from the chassis.
Removing the Backplane from the Chassis
1. Power down the system as described in Section 5-2 and open the chassis
cover.
2. Disconnect the cabling to the backplane.
3. Remove all of the hard drive trays from the front of the chassis.
4. Remove the four upper screws at the top of the backplane, indicated by the
arrows below.
Figure 5-19. Removing the Screws at the Top of the Backplane
5-22
5