Arbor Plug; Mill Spindle Cover - Smithy GRANITE 1300 SERIES Operator's Manual

Arbor Plug

Install the plug setscrew (S12898 into the tailstock arbor before inserting the
arbor into the tailstock. A plug is installed in the tailstock arbor (the MT3 to JT33
arbor, part number C30523), which allows the ejector pin inside the tailstock to
eject the arbor when the tailstock barrel is retracted.
Morse Taper 3
tooling is used in the millhead of the machine and used in conjunction with a
drawbar.

Mill Spindle Cover

The mill spindle cover slides over the flange on the top of the millhead.
Do not operate your machine without the mill spindle
cover. Doing so could cause harm to yourself or your
machine.
! NOTICE !
MT3 Arbor
Figure 5.2 Installing Arbor Plug
(MT3) tooling is used in the tailstock of the machine. R-8
Figure 5.3 Installing Mill Spindle Cover
WARNING
Or Visit www.smithy.com
5: Preparing Your Machine For Operation
Plugs
5-2