Endmill Cutters - Smithy GRANITE 1300 SERIES Operator's Manual

Application
Cast Iron
Non-ferrous, non-metallic,
high-temperature alloys
200 and 300 Series
stainless steels
Alloy steels
400 Series stainless steel,
high velocity
*C-2 and C-6 are the most commonly used carbides.
When to Use Different Kind of Endmills
Choose milling cutters for the type of cut, the number of parts, and the material. Rake
angles depend on both cutter and work material. Clearance angles range from 3° to 6°
for hard or tough materials to 6° to 12° for soft materials.
To determine the number of teeth you want, consider the following:
• There should not be so many teeth that they reduce the free flow of chips.
• The chip space should be smooth so chips don't clog.
• Don't engage more than two teeth at a time in a cut.

Endmill Cutters

Endmill cutters cut on their ends and sides. They are either solid (cut from a single piece
of material) or shell (separate cutter body and shank). They have two, three, four, or
more teeth and may do right or left-handed cutting. Their flute twist or helix may also be
right or left-handed. Solid endmills have straight or tapered shanks; shell endmill adapters
have tapered shanks.
Endmills machine horizontal, vertical, angular, or irregular surfaces in making slots,
keyways, pockets, shoulders, and flat surfaces.
• Two-flute or center-cutting endmills have two teeth that cut to the center
of the mill. They may feed into the work like a drill (called plunge milling), then
go lengthwise to form a slot. Teeth may be on one end (single-ended) or both
ends (double-ended).
• Multiple-flute endmills have three, four, six, or eight flutes and may be
single or double-ended. Multiple-flute mills are center-cutting or non-center
cutting. Don't use noncenter-cutting endmills for plunge milling.
Use
Roughing cuts
General purpose
Light finishing
Precision boring
Roughing cuts
General Purpose
Finishing cuts
Precision boring
Or Visit www.smithy.com
Appendix A: Machining Reference Guide
Grade
C-1
C-2*
C-3
C-4
C-5
C-6*
C-7
C-8
A-11