Bar And Chain Combinations; Saw Chain Filing And File Gauges; Ec-Declaration Of Conformity; 115 10 81-95 Rev.1 2008-01-08 - Husqvarna 435e Operator's Manual

Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 445, 445e and 450e. The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and
vibration requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Bar and chain combinations

Chain saw models Husqvarna 445, 445e and 450e met the kickback performance requirements of ANSI B 175.1-2000 when
tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a low
kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We recommend
to use only the listed combinations of bars and chains for chain saw models Husqvarna 445, 445e and 450e. Other chain
saw models may not meet the kickback requirements when equipped with the listed bar and chain combinations.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below.
0,050"/1,3 mm H30
0,058"/1,5 mm -
Saw chain filing and file gauges
40 – English
TECHNICAL DATA
Bar
Thickness of drive
links, inch/mm
1,3
1,5
H22 H23
H25 H21
Max. nose radius Type
10T Husqvarna H30
10T
10T
10T
10T
10T Husqvarna H21/
Husqvarna H25
10T
10T
10T
12T
Chain
Drive link count
56
64
66
72
78
56
64
66
72
78

115 10 81-95 Rev.1 2008-01-08