3. Insert the replacement power supply module into the power supply cage until it
clicks into place.
4. Reconnect all power cables.
Replacing the Control Panel Module (Hot-swap Hard
Drive System only)
Your server system must be operated with a control panel installed.
Note: The Intel
Caution: The control panel is NOT hot-swappable. Before removing or replacing the control panel,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
1. Unplug the front panel and USB cables from the backplane (see letters "A" and "B"
in
2. Press the latch at the back of the control panel and push it forward (see letter "C" in
Figure
®
Intel
Server System SR1600UR Service Guide
A
Figure 77. Removing Power Supply Module from the Server System
B
Figure 78. Installing Power Supply Module into the Server System
®
Local Control Panel is only supported in hot-swap hard drive systems.
Figure
79).
79).
A
B
B
A
AF000366
AF000367
89