Safety Notice - Poulan Pro PP4620AVX Instruction Manual

Computed kickback angle (CKA) Table
MODEL P/N
PP4620AVX 952044815
NOTE:
If this saw is to be used for commer-
cial logging, a chain brake is required and
shall not be removed or otherwise disabled
to comply with Federal OSHA Regulations
for Commercial Logging.
WARNING:
The engine exhaust
from this product contains chemicals known
to the State of California to cause cancer,
birth defects or other reproductive harm.

SAFETY NOTICE:

Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or
abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool and seek
medical attention. An anti-vibration system
does not guarantee the avoidance of these
problems. Users who operate power tools on
a continual and regular basis must monitor
closely their physical condition and the
condition of this tool.
Protective gloves (not provided) should be
worn during assembly.
ATTACHING THE BUMPER
SPIKE
(If not already attached)
The bumper spike may be used as a pivot
when making a cut.
1. Loosen and remove bar knob completely
by lifting lever and turning counterclock-
wise.
2. Remove clutch cover.
3. Attach the bumper spike with the two
screws as illustrated.
ATTACHING THE BAR & CHAIN
already attached)
WARNING:
If received assembled,
repeat all steps to ensure your saw is prop-
erly assembled and all fasteners are secure.
Always wear gloves when handling the
BAR
Length CHAIN P/N
20" 952051310
SPECIAL NOTICE:
with a temperature limiting muffler and spark
arresting
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
to be equipped with a spark arresting screen.
If you operate a chain saw in a state or locale
where such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Failure to do so is
a violation of the law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
Failure to follow all Safety Rules and Precau-
tions can result in serious injury. If situations
occur which are not covered in this manual,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or call 1-800- -554- -6723.
STANDARDS:
writer's Laboratories, Inc. in accordance with:
ANSI B175.1- - 2000 American National
Standards for Gasoline- -Powered Chain
Saws - - Safety Requirements
CSA Z62.1- - 1995 Chain Saws - - Occupa-
tional Health and Safety
CSA Z62.3- - 1996 Chain Saw Kickback Oc-
cupational Health and Safety
ASSEMBLY
chain. The chain is sharp and can cut you
even when it is not moving!
NOTE: CHAIN BRAKE MUST BE DIS-
ENGAGED BEFORE IT CAN BE RE-
MOVED OR INSTALLED ON THE
CHAIN SAW. TO DISENGAGE CHAIN
BRAKE, PULL THE FRONT HAND
GUARD BACK TOWARD THE REAR
OF THE CHAIN BRAKE AS FAR AS
POSSIBLE (SEE ILLUSTRATION).
DISENGAGED
Front Hand Guard
(If not
6
CKA without chain brake
31_
Your saw is equipped
screen which meets
This saw is listed by Under-
ENGAGED
Chain Brake
the