Cooling System; Seasonal Storage - Poulan Pro PP4620AVX Instruction Manual

Hook Angle
Right
Too Much Hook Angle
Wrong
WARNING:
Maintain the proper
hook angle according to the manufacturer's
specifications for the chain you are using. Im-
proper hook angle will increase the chance of
kickback which can result in serious injury.
4. Check and lower depth gauges.
Depth Gauge Tool
S Place gauge tool on cutter.
S If the depth gauge is higher than the
depth gauge tool, file it level to the top of
the depth gauge tool.
S Maintain rounded front corner of
depth gauge with a flat file.
NOTE:
The very top of the depth
gauge should be flat with the front
half rounded off with a flat file.
If you require further assistance or are unsure
about performing this procedure, contact your
authorized service dealer or call our customer
assistance help line at 1- -800- -554- -6723.
IGNITION TIMING
Ignition timing is fixed and nonadjustable.
WARNING:
Perform the following
steps after each use:
S Allow the engine to cool, and secure the
unit before storing or transporting.
S Store chain saw and fuel in a well venti-
lated area where fuel vapors cannot reach
sparks or open flames from water heaters,
electric motors or switches, furnaces, etc.
S Store chain saw with all guards in place
and position chain saw so that any sharp
object cannot accidentally cause injury.
S Store chain saw well out of the reach of
children.

SEASONAL STORAGE

Prepare your unit for storage at the end of the
season or if it will not be used for 30 days or
more.
SPARK PLUG
The spark plug should be replaced each
0.025 inch
year to ensure the engine starts easier and
(0.65 mm)
runs better.
1. Loosen 3 screws on cylinder cover.
2. Remove the cylinder cover.
Rounded
3. Pull off the spark plug boot.
Corner
4. Remove spark plug from cylinder and
discard.
Squared Off
5. Replace with Champion RCJ- -7Y spark
Corner
plug and tighten with a 3/4 inch (19 mm)
socket wrench. Tighten securely. Spark
plug gap should be 0.025 inch (0.6 mm).
6. Reinstall the spark plug boot.
7. Reinstall the cylinder cover and 3 screws
Tighten securely.
File
Depth Gauge

COOLING SYSTEM

To keep the working temperature as low as
possible the machine is equipped with a
cooling system.
The cooling system consists of:
S Air intake on the starter
S Air guide plate
S Fins on the flywheel
S Cooling fins on the cylinder
S Cylinder cover (directs cold air over the
cylinder)
Clean the cooling system with a brush after
each use, more often in demanding condi-
tions. A dirty or blocked cooling system re-
sults in the machine overheating which
causes damage to the piston and cylinder.
STORAGE
If your chain saw is to be stored for a period
of time:
S Clean saw thoroughly before storage.
S Store in a clean dry area.
S Lightly oil external metal surfaces and
guide bar.
S Oil the chain and wrap it in heavy paper or
cloth.
FUEL SYSTEM
Under FUELING ENGINE in the OPERA-
TION section of this manual, see message
labeled IMPORTANT regarding the use of
gasohol in your chain saw.
Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum depos-
its during storage. Add stabilizer to the gaso-
line in the fuel tank or fuel storage container.
17
Spark Plug Boot