Adjusting The Anti-Scalp Rollers (For 42 Inch Mower Decks); Adjusting The Anti-Scalp Rollers (For 50 Inch Mower Decks) - Toro 74625 Operator's Manual

2
1. Height-of-cut lever
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower the
lever until it engages the position.
The transport position is the highest height-of-cut position or
cutting height 4.5 inch [115 mm] (Figure 23).
Adjusting the Anti-Scalp
Rollers (For 42 inch Mower
Decks)
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers to one of the following
positions:
•
Upper hole—use this position with the mower deck
in the 63mm (2-1/2 inch) and below height-of-cut
positions (Figure 24).
•
Lower hole—use this position with the mower
deck in the 76mm (3 inch) and above height-of-cut
positions (Figure 24).
3
1
G014476
Figure 23
3. 4.5 inch (115 mm),
Transport position
g019929
1. Anti-scalp roller
2. Lower hole—the mower
deck in the 76mm (3 inch)
and above height-of-cut
positions
3. Flange Nut
Adjusting the Anti-Scalp
Rollers (For 50 inch Mower
Decks)
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers as shown in Figure 25 to
match the closest height-of-cut position.
G010233
3
1. Anti-scalp roller
2. Bolt
33
4
5
Figure 24
4. Upper hole—the mower
deck in the 63mm
(2-1/2 inch) and below
height-of-cut positions
5. Bolt
4
1
2
Figure 25
3. Flange Nut
4. Hole spacing