Adjusting The Height-Of-Cut; Adjusting The Anti-Scalp Rollers (For 107 Cm (42-Inch) Mower Decks); Adjusting The Anti-Scalp Rollers (For 127 Cm (50-Inch) Mower Decks) - Toro 74656 Operator's Manual

Adjusting the Height-of-Cut

Note: The transport position is the highest height-of-cut
position or cutting height (115 mm (4.5 inches)) as shown
in Figure 19.
Height-of-cut is controlled by the lever located to the right of
the operating position (Figure
Adjusting the Anti-Scalp
Rollers (for 107 cm (42-inch)
Mower Decks)
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-lock position, and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers to one of the following
positions:
19).
Figure 19
•
Upper hole—use this position with the mower
deck in the 63 mm (2-1/2 inches) and below the
height-of-cut positions
•
Lower hole—use this position with the mower
deck in the 76 mm (3 inches) and above the
height-of-cut positions
g019929
1. Anti-scalp roller
2. Lower hole—the mower
deck in the 76mm (3
inches) and above the
height-of-cut positions
3. Flange nut
Adjusting the Anti-Scalp
Rollers (for 127 cm (50-inch)
Mower Decks)
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-lock position, and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers
closest height-of-cut position.
24
(Figure 20).
(Figure 20).
4
5
Figure 20
4. Upper hole—the mower
deck in the 63mm (2-1/2
inches) and below the
height-of-cut positions
5. Bolt
(Figure 21) to match the