Bluetooth Operation - Dual XDMA6415 Installation & Owner's Manual

• XDMA6415 OPERATION
Bluetooth® Operation
Overview
The XDMA6415 supports the HFP (hands-free profile). A2DP (advanced audio distribution
profile) and AVRCP (audio video remote control profile).
Preparation
Before you can use a mobile device with this head unit. it must be connected and
authenticated - commonly referred to as "pairing" a device. Please make sure that
Bluetooth is activated on your mobile device before you begin the pairing process. Refer
to the owner's manual of your mobile device for more details.
Bluetooth Pairing
1) To pair a Bluetooth enabled mobile phone to your head unit. press '\ on the head unit.
or press MODE to enter Bluetooth mode. BLUETOOTH will scroll once, then STANDBY will
appear if a phone is not paired and connected.
2) Press and hold '\ on the head unit for 5 seconds. until "PAIRING" is displayed. The
Bluetooth icon will flash every second. The head unit will begin to broadcast a signal for
60 seconds.
3) Complete the pairing from the Bluetooth menu of your mobile device by searching for
new devices. Please refer to your mobile device instructions for further information on
Bluetooth pairing and connections. The Bluetooth icon will illuminate solid.
The XDMA6415 device name is -DUAL BT.-
The password for the XDMA6415 is 1234.
Connedion Notes
elf ACNT is set to OFF, you must press '\ to connect after pairing.
eFrom Bluetooth standby mode. press ~ to disconnect your mobile device.
eFrom Bluetooth standby mode. press '\ to reconnect your mobile device if it has been
paired. but is not connected.
eTo connect a different mobile device. the currently connected mobile device must be
disconnected. If this device has been paired previously. you may reconnect using the
mobile device's Bluetooth menu. or repeat the above pairing instructions.
General Note
eDue to the differences in Bluetooth technology. some mobile devices may be
incompatible or function improperly when used with the XDMA6415.
e The external Bluetooth microphone must be connected to the wiring harness at the rear
of the unit to enable correct operation of a Bluetooth phone call.
22