NordicTrack NTL19011.0 User Manual page 20

If desired, adjust the
volume by pressing the
volume increase and
decrease buttons on the
console.
To pause the workout, touch one of the menu but-
tons or press the Stop button on the console. To
continue the workout, touch the Resume button or
the Start button. To end the workout session, touch
the End Workout button.
6. Measure your heart rate if desired.
Note: If you
use the hand-
grip heart rate
monitor and
the chest heart
rate monitor at
the same time,
the console
will not display
your heart rate
accurately. For
information about
the chest heart rate monitor, see page 14.
Before using the handgrip heart rate monitor,
remove the sheets of plastic from the metal con-
tacts. In addition, make sure that your hands are
clean.
To measure your heart rate, stand on the foot
rails and hold the contacts with your palms for
approximately ten seconds; avoid moving your
hands. When your pulse is detected, your heart
rate will be shown. For the most accurate heart
rate reading, continue to hold the contacts for
about 15 seconds.
Increase
Decrease
Contacts
7. Turn on the fan if desired.
The fan features multiple speed settings and an
auto mode. When the auto mode is selected,
the speed of the fan will automatically increase
and decrease as the speed of the walking belt
increases and decreases.
Press the Manual fan button
repeatedly to select a fan
speed or to turn off the fan.
Press the Auto fan button to
select the auto mode or to
turn off the fan.
8. When you are finished exercising, remove the
key from the console.
Step onto the walking platform and touch the home
button or the back button on the screen or press
the Stop button on the console. A workout sum-
mary will appear on the screen. After you view
the workout summary, touch the Finish button to
return to the main menu. You may also be able to
either save or publish your results using one of the
options on the screen. Then, remove the key from
the console and put it in a secure place.
When you are finished using the treadmill, press
the power switch into the off position and unplug
the power cord. IMPORTANT: If you do not do
this, the treadmill's electrical components may
wear prematurely.
20