Smartmix; Smarttemp - Bissell 7920 SERIES User Manual

Special Features of your BISSELL ProHeat Pro-Tech
The BISSELL SmartClean
The ProHeat Pro-Tech is a home cleaning system that automatically
mixes hand hot tap water with BISSELL Advanced Deep Cleaning
Formula and heats the solution as it is applied to the carpet. The
combination of heated cleaning solution, powered brush and suction
provide a safe and effective method of cleaning.

SmartTemp

Temperature control automatically heats the cleaning solution
as it is being applied to the carpet (*) to safely optimize
cleaning effectiveness.
The Power Switch controls power to the machine and the
1.
SmartTemp feature.
The SmartTemp Ready Light indicates the heater is ON. It
2.
is found on the front of the handle where it is easy to see
while you clean. Wait two minutes for the heater to warm
up before beginning to clean.
SmartTemp increases the water temperature approximately
3.
25° and will not allow it to exceed 180°.

SmartMix

Provides custom control for each cleaning job.
Lift the SmartMix Bottle up and out of the
1.
machine base.
Turn the SmartMix Bottle over so that the Valve Cap is
2.
in an upward position. Unscrew the Valve Cap and fill the
SmartMix Bottle to the mark with BISSELL Advanced Deep
Cleaning Formula.
Replace the Valve Cap, turning until snug.
3.
6
ug310-5815_7920E_604.indd 6 ug310-5815_7920E_604.indd 6
™
System
™
*SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
™
™
SmartTemp Ready Light
Power Switch
ON
SmartMix
Bottle
Valve Cap
3/29/06 3:39:43 PM 3/29/06 3:39:43 PM