Routine Maintenance - Bissell 7920 SERIES User Manual

Bare Floor Cleaning Technique
1.
2.
3.
4.
5.
6.

Routine Maintenance

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
ug310-5815_7920E_604.indd 17 ug310-5815_7920E_604.indd 17
Slowly move the machine Nozzle with Bare Floor Tool forward
and back over soiled surface one time while pressing the trigger.
Caution: Do not over wet.
Repeat the motion without pressing the trigger using the Bare
Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
Allow about 30 minutes for the floor to dry completely.
When the cleaning job is complete refer to the Maintenance
section on pages 17-19.
To remove Bare Floor Tool gently bend long tab (right side)
outward and pull tool down away from Nozzle. Rinse
thoroughly, dry and store
Turn Power Switch OFF.
Unplug power cord from the outlet and coil around Power Cord
Quick Release.
Remove and rinse tools in clean, running water. Dry and
replace on tool caddy.
Coil Flex Hose around storage brackets on Tool Caddy.
Remove Tank-In-Tank, dispose of dirty water. Refer to the
Features section on Pages 8-9.
Rinse out Tank-In-Tank and replace on the machine; Clean out
Lint Screen.
Clean out the Flow Indicator Filter each time it is used to ensure
best cleaning performance. Unscrew the Flow Indicator Cap, lift
out the Red Rotor and White Filter. Rinse all three parts in tap
water. Replace the Filter and Rotor. Replace the Flow Indicator
Cap; turn until snug, do not over-tighten.
Wipe all exterior surface with a soft cloth.
Store cleaner upright in a protected, dry area.
Note: ProHeat Pro-Tech uses water and must not be
stored where there is a danger of freezing. Freezing will
damage internal components and void the warranty.
When carpet is dry, vacuum again to remove hair and fuzz
that the ProHeat Pro-Tech may have loosened.
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
Tip:
SmartMix Bottle
may be stored with
cleaning solution
ready for your next
cleaning job.
Make sure dial is
turned to the Water
Rinse/ Carpet
Protector setting
when storing.
Cap
Rotor
Filter
17
3/29/06 3:39:49 PM 3/29/06 3:39:49 PM