Routine Maintenance - Bissell 7901 - AUTRE User Manual

Attach the Bare Floor Tool Continued
First attach left side (short Tab) catching Tab over Floor Nozzle edge.
5.
Gently bend long Tab (right side) outward to easily snap over
6.
edge of clear nozzle on left.
Machine Preparation
Set up machine following instructions in the Features
1.
section on pages 6-10. Be sure to thoroughly rinse out any
remaining BISSELL Advanced Deep Cleaning Formula from
the SmartMix Bottle to prevent slippery linoleum, vinyl, and
tile floors. Use BISSELL Floor Cleansing Formula in the
SmartMix Bottle.
Check ReadyTools Dial - it should be set on Floor Cleaning.
2.
Choose the SmartMix setting to match the cleaning job.
3.
Plug into a proper outlet and turn Power Switch ON. The SmartTemp
4.
Ready Light illuminates and the ProHeat II is ready to clean.
Bare Floor Cleaning Technique
Slowly move the machine Nozzle with Bare Floor Tool
1.
forward and back over soiled surface one time while
pressing the trigger.
Caution: Do not over wet.
Repeat the motion without pressing the trigger using the Bare
2.
Floor Tool to squeegee and suction up the dirty water.
Repeat steps 1 and 2 backing along the exit path.
3.
Allow about 30 minutes for the floor to dry completely.
4.
When the cleaning job is complete refer to the Maintenance
5.
section on pages 15-16 for machine cleanup and
storage instructions.
To remove Bare Floor Tool, gently bend long Tab (right side)
6.
outward and pull tool down, away from the Floor Nozzle. Rinse
thoroughly, dry and store.

Routine Maintenance

Turn Power Switch OFF.
1.
Unplug Power Cord from the outlet and coil around Power
2.
Cord Quick Release.
WARNING:
To reduce the risk of fire,
electric shock or injury
unplug from outlet before
servicing.
Tip:
SmartMix Bottle
may be stored
with cleaning
solution for your
next cleaning job.
Make sure dial
is turned to the
Water Rinse setting
when storing.
15