Control Functions; Control Panel - Sundance Spas 680 Series Owner's Manual

8.0

Control Functions

8.1

Control Panel

A. LED Display: Can display current
water temperature (default display),
water temperature set point, selected
filtration/heating mode, and error
messages.
B. Heat Indicator: Lit when heater is on.
C. Warmer (
D. Cooler (
E. Jets 1 Button: Turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump off.
F. Jets 2 Button (if equipped): Turns jets pump #2 on and off. Press
once for high speed; press a second time to turn pump off.
G. Light Button:
• Denali and Tacoma Models: Turns underwater light on in random
mode or in one of six solid colors. Refer to Section 9.3 (page 27)
for details.
• Edison and Peyton Models: Turns accent lights on in one of three
random modes or one of seven solid colors. Refer to Section 9.4
(page 28) for details.
• Hartford and Hawthorne Models: Turns underwater light and accent
lights on in one of three random modes or one of seven solid colors.
Refer to Section 9.4 (page 28) for details.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• All lighting systems run for 1 hour then shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes after
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
) Button: Increases water temperature set point.
) Button: Decreases water temperature set point.
680 SERIES
B
A
C D
E F
1 2
2 Pump Panel Shown
G
Page 23