Ati Firemv 2260 Baseplate Connections; Display Configurations - AMD ATI FireMV 2260 User Manual

6
9. Reconnect any cables that were disconnected during installation and plug in
the computer's power cord.
10.
Turn on the monitor, and then your computer.
If you have properly installed your graphics card, operating system messages will
appear and the boot procedure will proceed.
Your monitor will be running in a basic (VGA) video mode. Higher refresh rates are
not available at this stage of the installation. Once you have installed the ATI
FireMV drivers and software, you can use ATI Catalyst™ Control Center to adjust
your video settings and configure multiple monitors.
Proceed to install the software and drivers for your ATI FireMV graphics card.

ATI FireMV 2260 Baseplate Connections

The following figure shows the display connections available on your graphics
card.
Note: Baseplate may not appear exactly as depicted.
Figure 2–1 ATI FireMV 2260 Baseplate Connections
1 DisplayPort Connection
2 DisplayPort Connection
Note: This image shows a full-height baseplate; a low-profile baseplate is
also included in your ATI FireMV 2260 package.

Display Configurations

Your ATI FireMV 2260 graphics card provides dual-display functionality through
two DisplayPort connections.
Note: Up to 10 monitors may be supported using multiple graphics cards;
for more information, consult the ATI Catalyst Control Center online help.
The following table lists the different ways you can connect displays to your card:
ATI™ FireMV™ 2260
Hardware Installation
© 2008 Advanced Micro Devices, Inc.