Stamina 55-1529B Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 7:
Install the HEIGHT ADJUSTMENT BEAM(12) into MAIN FRAME(4) by pulling the SPRING
PIN(22) on the MAIN FRAME(4) and inserting the HEIGHT ADJUSTMENT BEAM(12) as shown. For added
safety, thread the SECURING KNOB(23) into the back side of the MAIN FRAME(4).
WARNING: Do not use the Assisted Inversion Pro until you have verified your height setting. Failure to
use the proper height setting can result in difficulty recovering from the decline position. See
HEIGHT ADJUSTMENT instructions on page 11.
1.
STEP 8:
Attach the end of the NYLON STRAP(31) to the hook on the back of the MAIN FRAME(4);
attach the end of the BUCKLE STRAP(32) to the hook on the FRONT FRAME(1), as shown in
Illustration 2. The NYLON STRAP(31) must be secured to the MAIN FRAME(4) and the BUCKLE
STRAP(32) must be secured to the FRONT FRAME(1).
STEP 9:
Attach the NYLON STRAP(31) to the BUCKLE STRAP(32) by inserting the end of the NYLON
STRAP(31) through the bottom of the BUCKLE, as shown in Illustration 3 (Steps A, B and C). The
NYLON STRAP(31) must be securely attached to the BUCKLE STRAP(32) through the BUCKLE.
The NYLON STRAP(31) and BUCKLE STRAP(32) are used to control the decline angle of the MAIN
FRAME(4). Check the decline angle before using the Assisted Inversion Pro. To increase the decline,
lengthen the straps. To decrease the decline, shorten the straps.
WARNING: DO NOT ALLOW table to invert past vertical. Table inverting past vertical may result in table
contacting frame, damage to table and serious injury to user due to fall hazard. Prior to each
use, make sure nylon and buckle straps are securely attached, as instructed in Steps 8 and
9. Adjust straps to desired angle of inversion, making sure that Main Frame does not strike
Front Frame at any time during use, as shown in illustrations on page 12.
2.
3.
9
BUCKLE
BUCKLE
A.
B.
C.