Stamina 55-1529B Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 4
Attach the FOOTREST(13) to the HEIGHT ADJUSTMENT BEAM(12) with HEX BOLTS(M8x1.25x50mm)
(47), WASHERS(M8)(51), and NYLOCK NUTS(M8x1.25)(49).
NOTE: The five holes in the FOOTREST(13) allow the FOOTREST(13) to be attached in three different
positions. Start with the center position and adjust if necessary. Use the outer position if users are
taller than average. Use the inner position if users are shorter than average.
STEP 5
Insert the OUTER PAD TUBE(15) through the hole on the HEIGHT ADJUSTMENT BEAM(12). Insert the
INNER PAD TUBE(14) into the OUTER PAD TUBE(15). Align the holes on the INNER PAD TUBE(14),
OUTER PAD TUBE(15), and HEIGHT ADJUSTMENT BEAM(12), then bolt them together with HEX BOLT
(M6x1x42mm)(43), WASHERS(M6)(50), and NYLOCK NUT(M6x1)(48).
WARNING: The PAD TUBES(14, 15) must be assembled with the ends pointed downward as shown. The
ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the
inversion table.
STEP 6
Insert the HEEL HOLDER TUBE(17) through the hole on the HEIGHT ADJUSTMENT BEAM(12) and
secure with HEX BOLT(M6x1x47mm)(44), WASHERS(M6)(50), and NYLOCK NUT(M6x1)(48). Place a
HEEL HOLDER BRACKET(18) onto a HEEL HOLDER(19), then slide them onto HEEL HOLDER TUBE(17)
together. Repeat on other side.
8