Stamina 55-1529B Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
STEP 10
Attach the LINKAGES(7) to the LEFT and RIGHT PIVOT ARMS(5, 6) with HEX BOLTS(M8x1.25x25mm)
(46), WASHERS(M8)(51), and NYLOCK NUT(M8x1.25)(49). DO NOT OVER TIGHTEN THE BOLTS.
STEP 11
Slide the LEFT and RIGHT PROTECTIVE COVERS(26, 27) onto each side of the BASE ASSEMBLY, and
pull the covers down until the bottom of the covers are slightly lower than the FOLDING LINKAGES(3).
Make sure the SHAFTS on the FRONT FRAME(1) poke out through the hole on the PROTECTIVE
COVERS(26, 27). Secure the PROTECTIVE COVERS(26, 27) to the FOLDING LINKAGES(3) with the
SECURING STRAPS on the covers.
NOTE: When the PROTECTIVE COVERS(26, 27) are assembled correctly the FOLDING LINKAGES(3)
should not be visible.
STEP 12
Attach the LEFT and RIGHT HANDRAIL ASSEMBLYS(8, 9) to the SHAFTS on both sides of the FRONT
FRAME(1) and then connect to the LINKAGES(7) with the LOCKING KNOBS(11).
STEP 13
Verify that the handlebars function correctly before using the Assisted Inversion Pro. Move the Nylon Bed
on the MAIN FRAME(4) backward toward the inverted position. The HANDRAILS(10) must move forward
as the MAIN FRAME(4) moves backward. If the HANDRAILS(10) do not move forward check ASSEMBLY
STEPS 2, 10, 11, and 12.
Shaft
Nylon Bed
Shaft
10