Duty Cycle; Specification Chart - Husky A05051 Operator's Manual

Become familiar with these terms
before operating the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per
minute; a unit of measure of air
delivery.
PSIG: Pounds per square inch
gauge; a unit of measure of pressure.
Code Certification: Products that
bear one or more of the following
marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified
independent safety laboratories and
meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-In Pressure: While the motor is
off, air tank pressure drops as you
continue to use your accessory.
Accessories for this unit are available at the store the unit was purchased.
This air compressor pump is capable of
running continuously. However, to
prolong the life of your air compressor,
it is recommended that a 50%-75%
Model No.
Bore
Stroke
Voltage/Hertz/Phase
Minimum Branch Circuit Requirement
Fuse Type
Air Reserve (gallons)
SCFM @ 40 psig
SCFM @ 90 psig
Contents of Carton
1 - Air Compressor
1 - Air Hose
1 - Blow Gun and Inflation Kit
(7 pieces)
1- Inflator/Deflator Kit (7 pieces)
A05051
GLOSSARY
ACCESSORIES

DUTY CYCLE

SPECIFICATION CHART

ASSEMBLY
8- ENG
When the tank pressure drops to a
certain low level the motor will restart
automatically. The low pressure at
which the motor automatically
restarts is called "cut-in" pressure.
Cut-Out Pressure: When an air
compressor is turned on and begins
to run, air pressure in the air tank
begins to build. It builds to a certain
high pressure before the motor
automatically shuts off, protecting
your air tank from pressure higher
than its capacity. The high pressure
at which the motor shuts off is called
"cut-out" pressure.
Branch Circuit: Circuit carrying
electricity from electrical panel to
outlet.
average duty cycle be maintained; that
is, the air compressor pump should not
run more than 30-45 minutes in any
given hour.
Y1010
1.875"
1.25"
120V/60/1
15 amps
Time Delay
1.75
3.0
2.0
Tools Required for Assembly
1 - 9/16" open end wrench or
adjustable wrench
1 - adjustable wrench