Dyson DC23 Operating Manual page 8

USINg YOUR dYSON vACUUM
CAUTION:
• The hose contains electrical wires. Do not use when damaged, cut, or punctured. Avoid
picking up sharp objects.
• Always turn off this appliance before connecting or disconnecting either hose or motorized
nozzle.
PLEASE NOTE:
• Do not use or store this machine below 32°F (0°C). Ensure that the machine is at room
temperature before operating.
• Do not allow the vacuum to be used by anyone who may not be able to operate it safely.
• The use of an extension cord is not recommended.
• Always switch off and unplug the vacuum before performing maintenance on your
vacuum.
• Ensure the cyclone is secured to the vacuum. Do not press the cyclone release button or
shake the vacuum while carrying or it could fall and cause injury.
• Store the vacuum indoors. Put the vacuum away after use with the cord coiled safely, to
prevent tripping hazards.
• Do not use outdoors or on wet surfaces or to vacuum water or other liquids – electric shock
could occur.
• Check to ensure your electricity supply corresponds to that shown on the rating plate,
which can be found behind the clear bin. The vacuum must only be used as rated.
• Do not lubricate any parts, or carry out any maintenance or repair work other than that
shown in this Dyson Operating Manual, or advised by the Dyson Helpline.
PLEASE NOTE:
• This vacuum is intended for domestic use only. Fine dust such as plaster dust or flour
should only be vacuumed in very small amounts.
• Do not use the vacuum to pick up sharp hard objects, small toys, pins, paper clips, etc.
They may damage the vacuum.
• Consult your flooring manufacturer's recommended instructions before vacuuming and
caring for your flooring, rugs, and carpet. The brush bar on the machine can damage
certain carpet types and floors.
• If unsure turn brush bar off in order to enable proper operation. Some carpets will fuzz if a
rotating brush bar is used when vacuuming. If this happens, we recommend vacuuming in
bare floors mode and consulting with your flooring manufacturer.
• When vacuuming, certain carpets may generate small static charges in the clear bin or
wand. These are entirely harmless and are not associated with the electricity supply. To
minimize any effect from this, do not put your hand or insert any object into the clear bin
unless you have first emptied it and rinsed it out with cold water (see 'clear bin cleaning
section).
CARPETS/hARd FlOORS
The brush bar will always default to 'ON' (spinning) each time you switch on the vacuum.
The brush bar will automatically stop if it becomes obstructed. If the brush bar stops during
use, please refer to the 'Clearing brush bar obstructions' section.
ClEAR bIN EMPTYINg
CAUTION:
• Switch 'OFF' vacuum and unplug the vacuum before emptying the clear bin.
PLEASE NOTE:
• Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. To remove
the clear bin from the vacuum press the button at rear of cyclone carrying handle.
• Do not use the vacuum without the clear bin in place.
• To minimise dust/allergen contact when emptying, encase the clear bin tightly in a plastic
bag and empty. Remove the clear bin carefully and seal bag tightly, dispose as normal.
ClEAR bIN ClEANINg
CAUTION:
• Do not immerse the whole cyclone in water or pour water into the cyclones.
• Ensure the clear bin is completely dry before replacing.
PLEASE NOTE:
• Do not use detergents, polishes or air fresheners to clean the clear bin.
• Clean the shroud with a cloth or dry brush to remove lint and dust.
• Do not put clear bin in a dishwasher.
WAShINg YOUR FIlTER
DO THIS EVERy 3 MONTHS
CAUTION:
• Switch 'OFF' and unplug the vacuum before removing the filter.
• Ensure filter is completely dry before refitting to the vacuum.
PLEASE NOTE:
• It is important to check your filter regularly and wash at least every 3 months according to
instructions, to maintain performance.
• The filter may require more frequent washing if vacuuming fine dust.
• Do not use detergents to clean the filter.
• Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave or
near an open flame.
8
lOOKINg FOR blOCKAgES
CAUTION:
• Switch 'OFF' and unplug the vacuum before checking for blockages. Failure to do so could
result in personal injury.
• Please ensure the vacuum is upright and switched off before removing hose or airway
inspection parts.
• Beware of sharp objects when clearing blockages.
• Refit all parts of the vacuum securely before using.
PLEASE NOTE:
• Clearing blockages is not covered by your vacuum's limited warranty.
• This vacuum is fitted with a thermal cut-out. If any part of your vacuum becomes blocked,
it may overheat and then automatically shut off. Switch 'OFF' and unplug the vacuum
and leave to cool down for at least 60 minutes before attempting to check filters or for
blockages. Clear blockage before restarting.
1
ClEARINg bRUSh bAR ObSTRUCTIONS
CAUTION:
• Switch off and unplug the vacuum before clearing brush bar obstructions. Failure to do so
could result in personal injury.
• If your brush bar is obstructed, it may shut off. If this happens you will need to remove the
brush bar as shown and clear any obstructing debris. Refit all parts securely before use.
• Beware of sharp objects when clearing obstructions.
• Refit all parts of the vacuum securely before using.
PLEASE NOTE:
• Cleaning the brush bar obstructions is not covered by your vacuum's limited warranty.
2
3