Qs434 - Q-See QS434 User Manual

QS434

FRONT PANEL
1 2 3
1 2 3 4 5
MENU
EXIT
6 7 8 9 0
Item # Name/ Symbol Description
1 STANDBY Press to set the system in standby mode. Press again to wake.
2 MENU/EXIT Press to open/close the main menu.
3 Press buttons 1-4 to view that channel full-screen
CHANNEL/
NUMBERS
Press buttons 1-0 to input passwords and user IDs.
▲
4 Press to move cursor up; in PTZ mode, press to pan
camera up.
▼
Press to move cursor down; in PTZ mode, press to
pan camera down.
NAVIGATION
◄
Press to move cursor left; in PTZ mode, press to pan
camera left.
►
Press to move cursor right; in PTZ mode, press to
pan camera right.
5 LED Shows status of hard drive, recording, alarm, HDD full and
INDICATORS network.
6 IR SENSOR IR Receiver for remote control.
7 In menus, press to confirm selections; in PTZ mode, press to
OK change the navigation buttons to control a connected PTZ
camera (not included)
◄ ◄
8 Increase reverse playback speed 1X, 2X, 4X.
/
Press to freeze playback to one frame, then press
►
n
again to advance frame-by-frame.
DURING
►
Press to start playback
PLAYBACK
PRESS:
► ► |
Press to slow playback speed by 1/2, 1/4, 1/8.
► ►
Press to increase forward playback speed 1X, 2X,
4X.
9 USB Connect a USB flash drive for data backup and
firmware upgrades
16
4 5
HDD REC ALM FULL NET
OK
7 8
REAR PANEL
6 1
AUDIO OUT
+
-
DC +19V
IN VIDEO OUT
4
5
9
Item # Connector
AUDIO
1
OUTPUT
2 VIDEO IN
3 AUDIO IN
4
5 VIDEO OUT
6 NETWORK
7 VGA OUTPUT
ALARM INPUT 8 I/O Alarm input
ALARM
OUTPUT
8 RS485
RS232
+12V
9 USB
2 3
VIDEO IN AUDIO IN
1 3 1 3
VGA
2 4 2 4
RJ45
6 7
Description
For connection to amplified speaker
Video input for connecting analog video signal input (BNC)
Audio input for connecting audio signal (4 feeds)
DC 19V Power Connection
Video output for connecting TV (BNC)
For connecting Ethernet cable
To connect to VGA monitor
I/O Output for alarm
RS485 for connecting PTZ
Debugging port
Power supply for DC relay, the current is 100MA (to prevent
short circuits)
Mouse port
USB
ALM IN
8 9
17