Qs464 - Q-See QS434 User Manual

QS464

FRONT PANEL
1 2
1 2 3
6 7 8
QS464
Item # Name/ Symbol Description
1 STANDBY Press to set the system in standby mode. Press again to wake.
2 Press buttons 1-4 to view that channel full-screen
Press buttons 1-0 to input passwords and user IDs.
DURING PLAYBACK PRESS:
◄ ◄
Increase reverse playback speed 1X, 2X, 4X.
CHANNEL/
/ Press to freeze playback to one frame, then press
►
n
NUMBERS/
again to advance frame-by-frame.
PLAYBACK
►
Press to start playback
► ► |
Press to slow playback speed by 1/2, 1/4, 1/8.
► ►
Press to increase forward playback speed 1X, 2X,
4X.
3 MENU/EXIT Press to open/close the main menu.
4 IR SENSOR IR Receiver for remote control.
5 LED Shows recording status and motion detection (Alarm).
INDICATORS
▲
6 Press to move cursor up; in PTZ mode, press to pan
camera up.
▼
Press to move cursor down; in PTZ mode, press to
pan camera down.
NAVIGATION
◄
Press to move cursor left; in PTZ mode, press to pan
camera left.
►
Press to move cursor right; in PTZ mode, press to
pan camera right.
7 In menus, press to confirm selections; in PTZ mode, press to
OK change the navigation buttons to control a connected PTZ
camera (not included)
8 USB The upper port is to connect a USB flash drive for
data backup and firmware upgrades.
The lower port is to connect a USB mouse.
18
3 4 5 6 7
4 5
MENU
OK
EXIT
9 0
REC ALARM
REAR PANEL
8 1 2
ON/OFF
AUDIO OUT
USB 2.0
- +
USB MOUSE
DC +12V
VIDEO OUT
IN
6 7
Item # Connector
1 Power Switch
AUDIO
2
OUTPUT
3 VIDEO IN
4 AUDIO IN
5 NETWORK
6
7 VIDEO OUT
RS485
8
RS232
9 USB
10 VGA OUTPUT
3 4 5
VIDEO IN AUDIO IN
1 3 1
RJ45
VGA
2 4 2
8 9 10
Description
Power On/Off
For connection to amplified speaker
Video input for connecting analog video signal input (BNC)
Audio input for connecting audio signal (2 feeds)
For connecting Ethernet cable
DC 12V Power Connection
Video output for connecting TV (BNC)
RS485 for connecting PTZ
Debugging port
Mouse port
To connect to VGA monitor
19