Rack Mounting The Hd-220 Appendix - Vidyo VidyoRoom HD-220 User Manual

Follow the steps in the order given to complete the installation process in a
minimal amount of time. Please read this section in its entirety before you be-
gin the installation procedure outlined in the sections that follow.
Decide on a suitable location for the rack unit that will hold the HD-220 unit. It
should be situated in a clean, dust-free area that is well ventilated. Avoid areas
where heat, electrical noise and electromagnetic fields are generated. You will
also need it placed near a grounded power outlet.
Choosing a Setup Location
A. Leave enough clearance in front of the rack to enable you to open the front
door completely (~25 inches [63.5cm]).
B. Leave enough clearance on top of the unit to enable intake fan to work
properly (minimum of 3/8 inches [1cm], recommended clearance is 1.75"
[4.44cm])
C. Leave approximately 30 inches [76.2cm] of clearance in the back of the rack
to allow for sufficient airflow and ease in servicing.
Rack Precautions
A. Ensure that the leveling jacks on the bottom of the rack are fully extended to
the floor with the full weight of the rack resting on them.
B. In a single rack installation, stabilizers should be attached to the rack.
C. In multiple rack installations, the racks should be coupled together.
D. Always make sure the rack is stable before extending a component from the
rack.
E. You should extend only one component at a time - extending two or more
simultaneously may cause the rack to become unstable.
F. Always keep the rack's front door closed when not servicing to maintain
proper cooling.
Basic HD-220 Bracket Installation Procedure
The HD-220 comes with two rack mounting brackets, which are attached on
each side at the front of the chassis with 3 screws.
TM
52

Rack Mounting the HD-220 Appendix