Datamax Mark II Operator's Manual page 68

Wireless Configuration - Adhoc Mode:
Note: The following example uses the DMXConfig software utility to configure the printer.

1. Connect the host to the printer with a
serial or parallel cable.
2. Turn ON the printer.
3. Launch the DMXConfig utility. Query the
printer by using the Query Printer toolbar
button (top-left). This will connect to the
printer and get the current printer settings.
4. Next select the Communications tab.
Select WLAN AdHoc, SSID = Unique and
then click the button to the right. The
printer will now reset itself and be
configured to the following settings:
Wireless Mode: Enabled
IP: 192.168.10.26
SSID: MAC Address of the printer (unique
value for each printer, listed on the
Network Report Label).
Subnet Mask: 255.255.255.0
Gateway: 192.168.10.26
BSS: 192.168.10.1 (This is the IP of the
radio card and is not to be used for data
transfer.)
Once the previous steps have been successfully completed you may now use the IP Address to:
> Install a printer driver, and start printing from your Windows
-or-
> Browse to the internal web pages for advanced configuration; see Section C.4.
60
applications; see Section C.6.
Appendix C – Ethernet Setup