Datamax Mark II Operator's Manual page 64

TCP/IP Configuration Page
Static IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Settings
Enable IP Discovery
(DHCP, BOOTP, etc.)
Network Services
Enable SNMP Service
Enable Telnet Service
Enable FTP Service
Wireless Settings
Enable Wireless
Advanced Settings
Port Number
Max Transmission Units
Gratuitous ARP (Minutes)
(0=disable)
Duplex Capability
Advertise Capability
SNMP Trap Destination
Address
NetBIOS (WINS)
Settings
NetBIOS Name
Primary WINS Server
Secondary WINS Server
Primary DNS Server
Secondary DNS Server
56
These are the static address the printer will use when IP Discovery is set to disabled or a
valid IP could not be retrieved from a DHCP server.
Controls IP Address discovery, where:
Checked: Broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway are
not allowed; and, if no server is found, the specified static value will be used.
Unchecked: Uses the stored static IP, Subnet Mask, and / or Gateway Address.
Allows management protocols, where:
Sends messages to SNMP-compliant devices.
Sends no messages.
Allows Telnet protocol to transfer data, where:
Telnets to remote computers or server systems.
Disables Telnet.
Allows FTP protocol to transfer data, where:
Enables FTP
Disables FTP
Enables or disables the Wireless communication (if equipped) of the network card.
Selects the Port to use for all network communications; the default is 9100.
Sets the Maximum Transmission Unit packet size, where:
Packet size, in bytes. (512-65515); the default is 1500.
Sets time interval for ARP transmission packets, where:
(0-2048 minutes); the default is 0.
Allows the User to specify the line duplex and speed of the wired Ethernet connection.
Auto-Negotiate (default)
100 BaseT Full Duplex
100 BaseT Half Duplex
Selects the method in which the Duplex Capability setting is advertised, where:
Automatic (advertises the selected Duplex Capability setting)
All Capabilities (advertises all capabilities)
Is the address in standard octet format where SNMP traps will be sent when SNMP
service is installed on your receiver. When zeroed, no traps are sent.
Is the name used to reference the printer instead of the IP address. A WINS or DNS
server is required for this capability.
The IP address of the primary WINS Server.
The IP address of a secondary WINS Server.
The IP address of the primary DNS Server.
The IP address the secondary DNS Server.
10 BaseT Full Duplex
10 BaseT Half Duplex
Appendix C – Ethernet Setup