Server Power Features; Turning On The Server - IBM eServer xSeries 345 Type 8670 User Manual

Ethernet 1 link status LED: This green LED is lit when there is an active link
connection on the 10BASE-T, 100BASE-TX, or 1000BASE-TX interface for Ethernet
port 1.
Ethernet 1 activity LED: This green LED is lit when the server is transmitting or
receiving signals to the Ethernet LAN that is connected to Ethernet port 1.

Server power features

This section contains information about how to properly turn your server on and off.

Turning on the server

You can turn on the server in any of the following ways:
v If the power cords are connected to a power source, you can press the
v If the server is turned on and a power failure occurs, it restarts automatically
v You can turn on the server by using the Integrated System Management
v You can turn on the server by using the optional Remote Supervisor Adapter.
v When you plug in your server for the first time, Wake on LAN
v If your server was previously turned on, it must be properly placed in Standby
Complete the following steps to manually turn on the server:
1. Review the information in "Safety" on page v.
2. Turn on all external devices, such as the monitor.
3. Plug the server power cords into the power source.
4. Press the power-control button on the front of the server.
Note: While the server is powering up, the power-on LED on the front of the server
power-control button on the front of the server.
Note: You can install a circular disk over the power-control button to prevent
accidental manual power-off. This disk, known as the power-control-button
shield, comes with your server.
when power is restored.
Processor (ISMP).
server.
mode for the Wake on LAN feature to turn on the server.
is lit.
Chapter 1. Introducing the IBM xSeries 345 Type 8670
®
can turn on the
9