Join Vlan Detail; Vlan Management > Gvrp; Statistics > Rmon Statistics - Linksys SRW2008 User Manual

Chapter 5
LAG Indicates if the port is a member of a LAG. If it is a
member of a LAG, it cannot be configured to a VLAN. The
LAG to which it belongs can be configured to a VLAN.

Join VLAN Detail

The Join VLAN Detail screen allows you to select the VLAN
for the port selected and determine whether it is tagged
or untagged. It will be displayed with a T if it is tagged and
with a U if it is untagged.
Join VLAN Detail
VLAN Management > GVRP
GARP VLAN Registration Protocol (GVRP) is specifically
provided for automatic distribution of VLAN membership
information among VLAN-aware bridges. GVRP allows
VLAN-aware bridges to automatically learn VLANs to
bridge ports mapping, without having to individually
configure each bridge and register VLAN membership.
VLAN Management > GVRP
The Global System LAG information displays the same
field information as the ports, but represent the LAG GVRP
information.
The GVRP screen is divided into two areas, GVRP and GVRP
Table. The field definitions for both areas are the same.
Enable GVRP Enables and disables GVRP on the device.
Interface DIsplays the interface on which GVRP is
enabled. The possible field values are:
8-Port 10/100/1000 Gigabit Switch with Webview
Advanced Configuration
Port Indicates the port number on which GVRP is
•
enabled.
• LAG Indicates the LAG number on which GVRP is
enabled.
GVRP State When the checkbox is checked, GVRP is
enabled on the interface.
Dynamic VLAN Creation When the checkbox is checked,
Dynamic VLAN creation is enabled on the interface.
GVRP Registration
When the checkbox is checked, VLAN
registration through GVRP is enabled on the device.
The Update button adds the configured GVRP setting to
the table at the bottom of the screen.
Statistics > RMON Statistics
The RMON Statistics screen contains fields for viewing
information about device utilization and errors that
occurred on the device.
Statistics > RMON Statistics
Interface Indicates the device for which statistics are
displayed. The possible field values are:
Port
• Defines the specific port for which RMON
statistics are displayed.
LAG Defines the specific LAG for which RMON
•
statistics are displayed.
Refresh Rate Defines the amount of time that passes
before the interface statistics are refreshed. The possible
field values are:
No Refresh Indicates that the RMON statistics are not
•
refreshed.
• 15 Sec Indicates
statistics are refreshed
that the RMON
every 15 seconds.
25