Hunter 42826-01 Owner's Manual And Installation Manual page 15

7 • Completing Your Installation With or Without a Bowl Light Fixture (Continued)
Uninstalling the Light Fixture
7-14. To uninstall the light fixture, first disconnect the plug
connectors between the black wire and the red wire.
7-15. Disconnect the plug connectors between the two white wires.
7-16. Uninstall the connector and washer from the end of the light
fixture inside the lower switch housing.
7-17. Unscrew the threaded rod of the light fixture from the lower
switch housing.
7-18. Remove the light fixture from the lower switch housing pulling
disconnected wires through the hole in the center of the lower
switch housing.
Note: When removing the wires, pull the thin plug connector
(male) through first, and then pull the other plug connector
(female) through the hole.
7-19. Install the dummy terminals (included in the sack parts) on
the two disconnected wires in the lower switch housing.
7-20. Screw the threaded rod into the lower switch housing.
7-21. Screw the cap and finial onto the threaded rod.
Male Dummy
Female Dummy
Terminal
Terminal
15
42826-01 • 02/18/10 • Hunter Fan Company
Threaded Rod
Steps 7-16 – 7-18
Threaded
Rod
Cap
Finial
Step 7-20 - 7-21
Lower Switch
Housing