Completing Your Installation - Hunter 42743-01 Installation And Operation Manual

7 • Completing Your Installation
Steps 7-1 – 7-3
Housing
Assembly
Screw
10
Steps 7-5 – 7-6
Lower Switch
Housing
Plug
Connector
Detail
Housing
Assembly Screw
Hunter Fan Company
7-1. To attach the upper switch housing, partially install two housing
assembly screws into the switch housing mounting plate.
7-2. Feed the upper plug connector through the center opening of the
housing.
7-3. Align the keyhole slots in the housing with the housing assembly
screws.
7-4. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots.
Install the remaining screw into the housing. Tighten all three
screws firmly.
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the
Upper
switch housing falling.
Switch
Housing 7-5. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fit together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
Plug
Connector
7-6. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch
housing with three #6-32 x 3/8" housing assembly screws.
CAUTION: Make sure the upper switch housing is securely
42743-01 • 04/15/07