About Your Dryer Features - GE DSXH47EG Technical Service Manual

About your dryer features.

Light
cover
Pry with
flat blade
Light
screwdriver
housing
Signal Option
When the signal is on it will sound just
before the end of the cycle to remind
you to remove the clothes.
If the dried load cannot be removed
promptly during the cycle, the Cycle
Selector will advance to the EXTENDED
COOL DOWN setting. Unheated tumbling
continues during EXTENDED COOL DOWN
and WRINKLE CARE (on some models)
for 40 minutes to help reduce wrinkling.
When the CYCLE SIGNAL is on, it will
sound briefly every five minutes as a
reminder to remove the load.
Wrinkle Care
Use this option to minimize the wrinkles
in clothes. It provides approximately 15
minutes of no-heat tumbling after the
clothes are dry.
This option can only be used with the
PERMA PRESS and DELICATE cycles.
Replacing the Dryer Light Bulb
WARNING:
risk of electric shock, disconnect this
appliance from the power supply
before attempting any user
maintenance. Turning the controls
to the OFF position does not
disconnect this appliance from the
power supply.
The dryer light is located above the dryer
door opening.
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution
Drying Rack (on some models)
A handy drying rack may be used for drying
articles such as stuffed toys, pillows or
washable sweaters.
1 Remove the lint screen.
2
Place the front bar under the lip of the
lint screen opening.
3 When items are dry, remove the rack
and replace the lint screen. DO NOT
OPERATE THE DRYER WITHOUT THE LINT
SCREEN IN PLACE UNLESS THE DRYING
RACK IS IN PLACE.
NOTE:
If items are removed before the end of
the cycle, press the CANCEL button twice.
Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles wonÕ t set in.
Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles wonÕ t set in.
panel by removing the fuse or switching
To reduce the
off the circuit breaker.
To replace the dryer light:
1 Using a small flat blade screwdriver,
pry the bottom of the light cover out
and off the light housing.
2
Unscrew the bulb when cool and
replace it with an appliance bulb of
the same or lower wattage.
3 Snap the light cover back on the light
housing.
NOTE:
The drying rack must be used with the
TIMED DRY cycle.
Do not use this drying rack when there
are other clothes in the dryer.
12