Epson EB-Z8455WU User Manual page 86

Problem Solving
Status Cause
Replace Lamp The lamp indicated by flashing indicator, lamp 1 or 2, is due for replacement. Replace it with a new lamp. s
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may explode increases.
Replace it with a new lamp as soon as possible.
We recommend replacing both lamps together to maintain consistent hue and brightness of projected images.
Lamp Warning Check the following two points.
• Remove the lamp indicated by the flashing indicator, lamp 1 or 2, and check if it is cracked. s
Supply System Warning
• Clean the air filter. s
(Ballast)
If it is not cracked: Re-fit the lamp and turn on the power.
If the error continues: Replace the lamp with a new lamp and turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local
dealer or the nearest address provided in the Support and Service Guide. s
If it is cracked: Replace it with a new lamp, or contact your local dealer for further advice. (Only one lamp is working. Replace
the burned-out lamp as soon as possible.). s
If replacing the lamp yourself, be careful to avoid pieces of broken glass.
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down when the projector is installed in a direction
which is not horizontal. s
No Air Filter Check that the air filter is securely installed. s
Air Flow Sensor Err. The projector automatically turns off about one minute after it detects that there is no air filter.
If the error continues even though an air filter is installed, the air filter sensor may be defective. Stop using the projector,
disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the
Support and Service Guide. s
Low Air Flow (This is not an abnormality. However, projection stops automatically if the airflow falls any further.)
The message "The air filter is clogged. Clean or replace the air filter." is displayed. Check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.98,
If the Low Air Flow status continues after cleaning the air filter, replace the air filter with a new one. s
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical
outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s
Contact List
Remedy or Status
p.98
Epson Projector Contact List
p.57
p.104
Epson Projector Contact List
p.104
p.101
p.101
Epson Projector Contact List
p.57
p.104
Epson Projector
86