Power Led/Speaker; Overheat Led; Chassis Intrusion; Wake-On-Lan - Supero AS2021M-T2R+ User Manual

Power LED/Speaker

On JD1, pins 1, 2, and 3 are for the
power LED and pins 4 through 7 are
for the speaker. See the tables on the
right for pin defi nitions.
Note: The speaker connector pins are
for use with an external speaker. If
you wish to use the onboard speaker,
you should close pins 6 and 7 with a
jumper.

Overheat LED

Connect an LED to the JOH1 header
to provide warning of chassis over-
heating. See the table on the right for
pin defi nitions.

Chassis Intrusion

A Chassis Intrusion header is located
at JL1. Attach the appropriate cable
to inform you of a chassis intrusion.

Wake-On-LAN

The Wake-On-LAN header is desig-
nated JWOL. See the table on the
right for pin defi nitions. You must
have a LAN card with a Wake-On-LAN
connector and cable to use the Wake-
On-LAN feature.
(Note: Wake-On-LAN from S3, S4, S5
are supported by LAN1. LAN2 sup-
ports Wake-On-LAN from S1 only.)
Chapter 5: Advanced Serverboard Setup
PWR LED Connector
Pin Defi nitions (JD1)
Pin# Defi nition
1 +Vcc
2 Control
3 Control
Speaker Connector
Pin Defi nitions (JD1)
Pin# Defi nition
4 Red wire, +5V
5 No connection
6 Buzzer signal
7 Speaker data
Overheat LED
Pin Defi nitions (JOH1)
Pin# Defi nition
1 3.3V
2 OH Active
Chassis Intrusion
Pin Defi nitions (JL1)
Pin#
1
2
Wake-On-LAN
Pin Defi nitions
Pin#
1
2
3
5-17
Defi nition
Battery voltage
Intrusion signal
(JWOL)
Defi nition
+5V Standby
Ground
Wake-up