4.
DRIVE BELT REPLACEMENT
4.1.
Insert a 1/2" breaker bar into the square hole on
the tensioner arm.
4.2.
Pull the breaker bar to the right until it can be
braced in position at the pivot point of the ten-
sioner arm. See Figure 4.2.
Idler arm
Figure 4.2
4.3.
Remove the belt from the transmission pulleys,
tensioner pulley and the crankshaft pulley.
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
5.
5.1.
5.2.
5.3.
5.4.
5.5.
3
SERVICING ELECTRIC PTO CLUTCH
Unplug the clutch.
Using a 9/16" socket and an impact wrench,
remove the clutch bolt. See Figure 5.2.
7/16-20 x 4.0 Hex cap screw
Figure 5.2
Lower the clutch off of the crankshaft.
Remove the crankshaft key.
Remove the crankshaft pulley. See Figure 5.5.
Crankshaft pulley
Figure 5.5
Key