Two People; Machine Set-Up - Alto Apollo 8 Operator's Manual

How to Transport the Machine
(cont.)
Note: It is not necessary to adjust the fan belt
independently during this procedure or during
replacement. The idler pulley is factory adjusted.
6. Close the belt guard door.
7. Plug the motor pigtail in, twisting to lock.
Transporting the Machine - Two People
When transporting the machine with two people
follow this procedure.
1. One operator places hands under the front of the
machines main casting.
2. Person #2 lifts the machine by the handle.

Machine Set-Up

To set-up your machine follow this procedure:
1. Familiarize yourself with the machine and read all
danger, warning and caution statements. Make
sure all operators of this machine have read this
Owner's Manual. If they cannot read English, have
the manual explained fully before allowing anyone
to operate the sander.
2. Locate the power supply. The receptacle should
be compatible with the plug. The receptacle must
be grounded and must be fused (30 amp) to avoid
an electrical hazard.
3. Clip the dust bag to the elbow. See figure # 5.
Cross the strings on the dust bag and draw tight
over the flare on the elbow. Wrap the string around
the elbow and secure.
4. Wind the power cord through the cable arm. See
figure #6. Keep the power cord out of path of
equipment.
5. Pull the draw latch forward to release the access
door to gain entry to the sanding chamber.
6. Rotate the release lever forward. See Figure #7.
Page 8 AMERICAN SANDERS TECHNOLOGY Apollo 8 Operator's Manual
Figure 5
Figure 6
Figure 7