Page 1
This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your ALTO machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
AMERICAN SANDERS TECHNOLOGY American Classic Sander 8 Assembly Drawing #1 11/00 15 16 IVIE Enterprises www.ivie-ent.com Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807 Page 20 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual...
Page 3
NOTE: Kindicates a change has taken place since last publication of this manual * Note: Tension Assembly breakdown and parts list are on pages 22 and 23. IVIE Enterprises www.ivie-ent.com Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual Page 21...
Page 4
AMERICAN SANDERS TECHNOLOGY American Classic Sander 8 Tension Assembly Drawing 10/99 IVIE Enterprises www.ivie-ent.com Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807 Page 22 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual...
Qty. Part # Description Qty. 50563A End Bell 51188A Bearing Front 52768A Front Cover 902547 Bearing Rear 53998A 40316A Armature Assembly 52769A Fan Cover IVIE Enterprises www.ivie-ent.com Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual Page 25...
NOTE: 43A/45A - Part # 64806A - Wheel, Steel (optional) - Qty. 2 **NOTE: #63 & #76 only one shown NOTE: Kindicates a change has taken place since last publication of this manual IVIE Enterprises www.ivie-ent.com Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual Page 27...
Page 10
AMERICAN SANDERS TECHNOLOGY American Classic Sander 8 Wiring Diagram 7/93 Page 28 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual...
If chatter becomes present, first replace abrasive belt from another lot, to insure that the abrasive is not at fault. AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual Page 29...
5.) CONTACT WHEELS ..may become out of round or unbalanced and leave chatter. Contact your American Sanders Technology dealer if this problem should occur. 6.) BEARINGS ..in the motor, arbor shaft, or fan system, of poor quality or worn and damaged will leave chatter.