Installing A Dvd-Rom Or Cd-Rom Drive Into Slimline Bay (No Backplane Installed) - Intel SR2400 User Manual

Hardware Installations and Uprades
9. Remove the two screws at the rear of the CD-ROM or DVD-ROM drive to disconnect the
interposer board.
10. Store the screw and interposer board for future use. Suggestion: tape the screw to the drive
carrier.
11. Install the slimline filler panel in the chassis opening.
12. Install the chassis cover. For instructions, see
13. (Optional) Install the front bezel. For instructions, see
14. Plug all peripheral devices and the AC power cable back into the server.
Installing a DVD-ROM or CD-ROM Drive into Slimline Bay (No
Backplane Installed)
NOTE
The carrier for the slimline DVD-ROM drive / CD-ROM drive was pre-
installed in the slimline drive bay of your Server Chassis SR2400. The
interposer board and floppy drive power adapter cable used in these
instructions was sent to you with your fixed drive kit.
1. Observe the safety and ESD precautions at the beginning of this book. See
Information."
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see
4. Remove the front bezel if it is installed. For instructions, see
5. Push in on the blue lever at the rear of the CD-ROM / DVD-ROM drive carrier and push the
carrier out through the front of the chassis.
"Installing the Chassis Cover."
"Installing the Front Bezel."
"Removing the Chassis Cover."
"Removing the Front Bezel."
"Safety
85