Figure 76. Connecting The Tape Drive Cables - Intel SR2400 User Manual

Hardware Installations and Uprades
9. Attach the end of the SCSI cable that is labeled "Tape Drive" to the SCSI connection on the
tape drive.
10. Route the SCSI cable along the front of the fan module and then through the front and rear
openings on the underside of the air baffle. You may need to remove the air baffle to route the
cable. For instructions on removing and installing the air baffle, see
swap Air Baffle (Backplane Installed)
(Backplane Installed)."
11. Route the end of the SCSI cable that is labeled "Server Board" to the server board or add-in
card connector. Push the cable through the opening in the backplane, as shown in the figure
below. See your server board or add-in card documentation to locate the connection point on
the server board or add-in card.
12. Connect the 7-pin tape drive power cable to the backplane connector that is labeled "OPT
CONN".
13. Connect the 4-pin tape power cable to the tape drive.
14. Install the chassis cover. For instructions, see
15. (Optional): Install the front bezel. For instructions, see
and "Installing the Large Hot-swap Air Baffle
"Installing the Chassis Cover."

Figure 76. Connecting the Tape Drive Cables

"Removing the Large Hot-
"Installing the Front Bezel."
TP01358
109