Unpacking; Proper Location; Assembly Instructions; Installing Your Water Dispenser - Haier WDNS045 User Manual

UNPACKING

1. Remove all packing materials. This includes the foam base and all adhesive
tape ................................ holding the accessories inside and outside.
2. Inspect and remove any remaining packaging, tape and printed material
before
turning on the water dispenser.
Note: Allow the water dispenser to stand in an upright position for at least
10 hours before turning on the power.

PROPER LOCATION

• To ensure that your water dispenser works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation and electrical connections.
• The following are the recommended clearances around the water dispenser.
Sides 2" (50mm)
Back 4" (100mm)
• Do not install your water dispenser in any location that is not properly insulat-
ed or heated because the unit is not designed to operate in room tempera-
ture below 55˚F / 13˚C. The water dispenser is for indoor use only. Room
temperature should not exceed 97° F / 36° C.
Note: The built-in thermostat maintains the hot and cold temperatures
automatically. On the compressor cooled water coolers the hot water
temperature will be between 185˚- 201.2˚ F/ 85˚- 94˚ C and the cold
water temperature will be between 39.2˚- 50˚ F/ 4˚-10˚ C.
• Select a suitable location for the unit on a hard even surface away from direct
sunlight and heat sources (e.g., radiators, baseboard heaters, cooking
appliances, etc.).
Note: Hot and cold water will not be instantly available as the unit will need
time to heat up and cool down the water.
CAUTION: DO NOT plug in the water dispenser until water flows
through both Hot and Cold water faucets.

ASSEMBLY INSTRUCTIONS

Read carefully and understand all installation instructions before installing the
water dispenser.

Installing Your Water Dispenser

Follow the steps below to install the water dispenser.
1. Remove the cap from the water bottle first. Lift up the water bottle and
quickly place it into the water guard. (The water bottle is not included.)
2. DO NOT plug in the water dispenser until you have checked that water flows
out of both the red and blue faucets when pressed. Never turn on the water
dispenser without water in it. Doing so may cause the unit to catch fire or
malfunction.
3. Check that water flows out by pressing both the red and blue water release
but tons one at a time.
4. Plug the power cord into an 115volt / 60 Hz outlet.
5. To activate the water heater and cooler, turn ON the red and blue switches
on the back of the unit. The hot & cold indicators in the front will be lit.
English
4