Table of Contents
Advertisement
9.1.7 BATTERY
1) Bat Cal
: This displays the value of Battery Calibration. The following menus are
2) TEMP Cal : This displays the value of Temperature Calibration. The following menus are
9.1.8 Audio
This is a menu for setting the control register of Voiceband Baseband Codec chip.
Although the actual value can be written over, it returns to default value after switching off and
on the phone.
1) VbControl1 : VbControl1 bit Register Value Setting
2) VbControl2 : VbControl2 bit Register Value Setting
3) VbControl3 : VbControl3 bit Register Value Setting
4) VbControl4 : VbControl4 bit Register Value Setting
5) VbControl5 : VbControl5 bit Register Value Setting
6) VbControl6 : VbControl6 bit Register Value Setting
9.1.9 DAI (Digital Audio Interface)
This menu is to set the Digital Audio Interface Mode for Speech Transcoder and Acoustic testing.
1) DAI AUDIO
2) DAI UPLINK
3) DAI DOWNLINK : Speech decoder test
4) DAI OFF
9.2 RF Test [MENU 2]
9.2.1 SAR test
This menu is to test the Specific Absorption Rate.
1) SAR test on : Phone continuously process TX only.
2) SAR test off : TX process off
displayed in order : BAT_LEV_4V, BAT_LEV_3_LIMIT, BAT_LEV_2_LIMIT,
BAT_LEV_1_LIMIT, BAT_IDLE_LI MIT, BAT_INCALL_LIMIT,
SHUT_DOWN_VOLTAGE, BAT_RECHARGE_LMT
displayed in order : TEMP_HIGH_LIMIT, TEMP_HIGH_RECHARGE_LMT,
TEMP_LOW_RECHARGE_LMT, TEMP_LOW_LIMIT
: DAI audio mode
: Speech encoder test
: DAI mode off
Call-setup equipment is not required.
- 111 -
9. ENGINEERING MODE
Advertisement
Table of Contents
