Table of Contents
Advertisement
10.2 RF Test [MENU 2]
Radio Frequency Test
A. SAR Test [2-1]
This menu is to test the Specific Absorption Rate.
• SAR Test On [2-1-1] : Phone continuously process TX only. Call-setup equipment is not
required.
• SAR Test Off [2-1-2] : TX process off
10.3 MF Mode [MENU 3]
This manufacturing mode is designed to do the baseband test automatically. Selecting this
menu will process the test automatically, and phone displays the previous menu after
completing the test.
A. All auto test [3-1]
LCD, LED, Backlight, Vibrator, Buzzer, and Key Pad are tested in order for a certain time.
B. Backlight [3-2]
LCD Backlight and LED Backlight are on for about 1.5 seconds at the same time, then off.
C. Buzzer [3-3]
This menu is to test the volume of Melody. It rings in the following sequence.
Volume 1, Volume 2, Volume 3, Volume 0 (mute), Volume 4, Volume 5.
D. Vibrator [3-4]
Vibrator is on for about 1.5 seconds.
E. LCD [3-5]
Main LCD screen resolution tests horizontally and vertically one by one and fills the screen.
F. Key pad [3-6]
When a pop-up message shows 'Press Any Key', you may press any keys including side
keys, but not [Soft2 Key]. If the key is working properly, name of the key is displayed on the
screen. Test will be completed in 15 minutes automatically and the screen displays the
previous one.
10. ENGINEERING MODE
- 97 -
Advertisement
Table of Contents
