Table of Contents
Advertisement
WARNING:
Failure to position the parts in accordance with all included
pictures, diagrams and drawings, or failure to use only parts
specifically approved with this appliance may result in property
damage or personal injury.
IMPORTANT
Cover the pilot and valve assembly, and for Liquid Propane
units, the air mixer at the side of the burner to protect it before
installing sand and glowing embers.
1.
Pour the provided sand (Note: use vermiculite for Liquid
Propane appliances) over the entire burner, filling the burner
pan. The sand (vermiculite) should follow the slope of the
burner pan, covering the burner completely. See Figure 17.
2.
Spread the Glowing Embers over the bottom portion of the
burner. See Figure 18.
WARNING:
Apply loose material (embers and lava rock [cinders]) per
instruction manual. DO NOT apply extra material not supplied
with this appliance. All previously applied loose material (em-
bers) must be removed prior to reapplication.
CAUTION:
DO NOT place glowing embers, sand vermiculite or lava rock
(cinders) in the area of the safety pilot assembly.
Page 12
FINAL SET UP
Figure 17
Figure 18
Figure 19
Refer to the log set up instructions packaged with your Decora-
tive Gas Logs (Box Two).
3.
Remove all contents from the Decorative Gas Log shipping
container (Box Two).
4.
Check the contents of the shipping container against the
shipping and packing list or the parts list in this manual.
Report any missing or damaged parts to your retailer.
5.
Remove any and all protective wrapping from the gas logs.
6.
Arrange the decorative gas logs on the grate.
7.
Place the Lava Rock (cinders) around the Grate/Burner As-
sembly. See Figure 19.
8.
DO NOT pack cinders around valve. The valve will overheat!
You must allow air flow around the valve.
9.
When you have completed setting up the logs, proceed to
the operation section on page 10 for Match Throw Units, and
page 11 for units with gas control valves.
STOP!
FG10239-1-0214
Advertisement
Table of Contents
