Shutting Down The Projector; Direct Power Off - BenQ TS521P User Manual

Shutting down the projector

1. Press
If you don't respond in a few seconds, the message will disappear.
2. Press
the projection lamp shuts down, and the fans will continue to run for approximately
90 seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling process.
To shorten the cooling time, you can also activate the Quick cooling function. See
for details.
3. Once the cooling process finishes, a "Power Off
Ring Tone" will be heard. The POWER indicator
light is a steady orange and fans stop. Disconnect
the power cord from the power outlet.
• To turn off the power ring tone, see
Off Ring Tone" on page 33
• If the projector is not properly shut down, to protect the lamp,
when you attempt to re-start the projector, the fans will run for a
few minutes to cool down. Press
projector after the fans stop and the POWER indicator light
turns orange.
• Lamp life results will vary depending on environmental conditions
and usage.

Direct power off

The AC power cord can be pulled out right after the projector is turned off. To protect
the lamp, wait about 10 minutes before re-starting the projector. (When you attempt to
re-start the projector, the fans may run for a few minutes to cool down. In such cases,
press POWER again to start the projector after the fans stop and the POWER
indicator light turns orange.)
POWER and a confirmation message will display prompting you.
POWER a second time. The POWER indicator light flashes orange,
"Turning off the Power On/
for details.
POWER again to start the
"Quick Cooling" on page 42
Operation 35