1-319-622-5511 outside U.S.A. select Commercial Microwave Ovens category. Warranty service must be performed by an authorized servicer. When contacting Amana, provide product information. Amana also recommends contacting an authorized Product information is located on oven serial plate. servicer if service is required after warranty expires.
IMPORTANT SAFETY INSTRUCTIONS Recognize this symbol as a SAFETY message WARNING When using electrical equipment, basic safety precautions should be followed to reduce the risk of burns, electrical shock, fire, or injury to persons. 1. READ all instructions before using equipment. 9.
IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING Liquids such as water, coffee, or tea are able to be To avoid risk of fire in the oven cavity: overheated beyond the boiling point without appearing to be boiling due to surface tension of the liquid. a.
This oven should be plugged into a separate circuit with the electrical rating as provided in product specifications (available on Amana’s wavelink website). When a microwave oven is on a circuit with other equipment, an increase in cooking times may be A—Allow at least 7 "...
Display and Features Single Pad Programming This feature enables each numbered pad to be programmed for a Start Pad specific use, such as cooking a certain number of potatoes or The start pad is used to defrosting and then cooking vegetables or other frozen foods. To begin a manual time entry use this feature, simply program the pad to the desired length of time and cooking cycle.
Page 7
Display and Features Cooking Display DISPLAYS DESCRIPTION READY displays when oven control will accept READY entries. There are words in the display that never Displays cooking time. If stage cooking is 00:00 programmed, total cooking time is displayed. actually display. COOK LEVEL COOK LEVEL displays while oven is operating.
Using the Oven Control Interrupting Manual Time Entry Operation To cook food using a specific entered time and power level. Open oven door or press STOP/RESET pad to interrupt 1. Open oven door and place food in oven. Close door. operation.
Programming the Oven Control Programming Pads Oven is shipped from the factory for single pad programming. To change the oven default to allow double pad programming, see User Options. To change the amount of time or the power level for a preset pad: X2 Programming 1.
User Options Changing user options Didn’t like an option? Factory settings are marked in bold. To Options such as single or double pad programming, beep volume, and change the oven back to the factory maximum cooking time can be changed to suit individual preferences. To change options: setting, simply select the option that is marked in bold.
Care and Cleaning Replacing Oven Light 1. Disconnect electrical supply. WARNING 2. Remove screw from side of oven. 3. While wearing protective gloves, To avoid electrical shock which turn light bulb counterclockwise can cause severe personal to remove. injury or death, unplug power 4.
2. Unplug oven, wait for 1 minute, and plug in oven. • Disconnecting electrical supply may eliminate service code. If failure continues, contact an authorized Amana servicer. Place one cup of water in oven. Oven operates but does not heat Run for one minute at full power (100%).