Outside Combustion Air - Drolet NG1800 Austral Owner's Manual

OUTSIDE COMBUSTION AIR

Your DROLET stove is approved to be installed with an outside air intake which is necessary for
a mobile home. This type of installation is also required in air tight houses and houses with
negative pressure problems. You can purchase this option through your DROLET dealer. Make
sure to specify this part number: #AC02080. Installation instructions are supplied with the air
intake kit.
Outside combustion air may be required if:
1. Your stove does not draw steadily, smoke rollout occurs, wood burns poorly, or back-
drafts occur whether or not there is combustion present.
2. Existing fuel-fired equipment in the house, such as fireplaces or other heating appliances,
smell, do not operate properly, suffer smoke roll-out when opened, or back-drafts occur
whether or not there is combustion present.
3. Opening a window slightly on a calm (windless) day alleviates any of the above
symptoms.
4. The house is equipped with a well-sealed vapour barrier and tight fitting windows and/or
has any powered devices that exhaust house air.
5. There is excessive condensation on windows in the winter.
6. A ventilation system is installed in the house.
WARNINGS for use in MOBILE HOMES:

DO NOT INSTALL IN BEDROOM

THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR
.
MAINTAINED

THE STOVE MUST BE ATTACHED TO THE STRUCTURE OF THE MOBILE HOME

INSTALL IN ACCORDANCE WITH

USE A FACTORY BUILT CHIMNEY THAT COMPLY WITH
T
IT MUST BE A YPE
.
24 ,
CFR PART
HT (2100 °F).
,
WALL
3280 ( ).
HUD
UL 103 ULC S629
OR
, /
AND CEILING ROOF MUST BE
.
;
STANDARDS THEREFORE
26