2.3 System requirement
Hardware
Item
Local console side
Network Side
Remote Console side
Computer side
Software
Item
Local host side
Remote Console side
2.4 When the server is up and running
The IP-KVM switch gives you a full control over the remote server. The Management Console
allows you to access the remote server's graphics, keyboard and mouse and to send special
commands to the server. You can also perform periodic maintenance of the server. Using the
Console Redirection Service, you are able to do the following:
I.
Reboot the system
II.
Watch the boot process.
III. Boot the system from a separate partition to load the diagnostic environment.
IV. Run special diagnostic programs.
2.5 When the server is dead
Obviously, fixing hardware defects is not possible through a remote management device.
Nevertheless IP-KVM switch gives the administrator valuable information about the type of a
hardware failure. Serious hardware failures can be categorized into five different categories with
different chances to happen:
I.
Hard disk failure 50%
II.
Power cable detached, power supply failure 28%
III. CPU, Controller, main board failure 10%
IV. CPU fan failure 8%
V.
RAM failure 4%
One VGA Monitor
One Keyboard
One Mouse
10/100Mbps Ethernet or Modem
One computer
PCs with 3-in-1 cables (One HDDB 15-pin male to one HDDB
15-pin and two Mini Din 6-pin PS/2 cables)
No additional software necessary
(1) Java Runtime Environment : version 1.4.2 or above
(2) Browser: Microsoft Internet Explorer version 6.0 or above or
Netscape or Mozilla or Safari
14 / 92
Description (8-port)
Description
8/16-Port KVM over IP Switch