Asko D5132 Use & Care Manual page 33

Installation
Slide the dishwasher into place
• Pull the drainage hose and connection pipe
when the machine is pushed into place.
• Check that the hose has no kinks or sharp
bends, and check that there is nothing that can
damage the hoses.
Installing the plinth (kick plate)
The dishwasher has two kick­plates (some mo­
dels). The taller one should be used if the mach­
ine is to be 850 ­ 870 mm high and the depth of
the plinth can be varied between 45 ­ 105 mm.
The lower one is to be used if the machine will
be 820 ­ 845 mm with a plinth depth of between
50 ­ 105 mm. Attach the enclosed felt insulation
to the kick­plate (some models).
Set the correct plinth depth as follows:
1. Bring the grey hooks towards each other and
pull out the brackets as far as required. Press
in the catches so that they lock the brackets in
place.
2. Suspend the kick­plate from the brackets by
pushing into the
slots.
Screw the dishwasher into place
The enclosed plastic plugs are used for covering
the screw holes if the dishwasher is to be scre­
wed at the sides. After fixing check that the front
feet are in contact with the floor.
Fitting strip seal
(on floor plinth covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping with
both hands under the plastic plinth (A), and
lift outwards and upwards.
2. Undo the two screws on the covering plate
(B).
3. Glue the accompanying rubber strip (C) to
the underside of the covering plate (against
the floor).
4. Screw the covering plate back into place.
Adjust the covering plate so that the rubber
strip is just in contact with the floor.
x x
5. Replace the plastic plinth.
Not all models
B
A
x
C