Technical Data - Asko D5132 Use & Care Manual

Installation
Connection to water
There must be a shut­off tap on the water supply
pipe. The shut­off tap should be easily acces­
sible.
The water supply pipe has a connection with a
1/2" internal thread.
When the installation is complete, the shut­off
tap should be opened to allow the pressure to
settle for a while and to check that all connec­
tions are tight.
Only use the inlet hose supplied with the machi­
ne. Do not reuse old or other loose inlet hoses.
NB!
It is recommended that connection should
be to cold water.
Connection to electricity
A dishwasher fitted with a lead and plug must
be connected to an earthed socket. Repairs and
maintenance relating to safety or performance
must be carried out by a qualified professional.

Technical data

See the type plate on the right side wall.
CAUTION!
The lead must be removed from the socket while
the work is carried out!
NB!
The hose must be fastened level with the under­
side of the sink unit.
It must be discharged at least 350 mm above
the bottom of the machine.
Illustration 1
Max 950 mm
Min 350 mm
Connection to drainage
When the drain hose is routed to a connection
nipple at the sink's water trap (see illustration 1),
note that the hose must be fastened level with
the underside of the sink unit – otherwise the
dishwater from the sink can run down into the
dishwasher. The drain hose is threaded onto a
cone­shaped connecting pipe at the sink unit's
water trap. The cone­shaped pipe must be cut to
an internal diameter of at least 16 mm. For other
alternative connections, see illustrations 2 and
3.
The drain hose may be lengthened by a maxi­
mum of 3 m (the total length of the drain hose
may not exceed 4.5 m). Any connections and
connecting pipes must have an internal diame­
ter of at least 16 mm. However, the drain hose
should ideally be replaced with a new hose
without joins.
Attach the drain hose with a securing clamp.
No part of the drain hose may be more than 950
mm above the bottom of the machine. The hose
must not be routed directly to the floor drain or
similar. In such cases, the hose can act as a
siphon and empty the dishwasher.
Illustration 2
Max 950 mm
Min 350 mm
Illustration 3
Max 950 mm
Min 350 mm
1